|
(Yes, I know I need
a better name but it's in line with WD40)
|
Update... Samples have been received
and evaluated. Production chassis are expected by the end of January 2017. |
|
Please note that the printed chassis may
deform to a point to where the motor magnets touch the armature,
this can be fixed by gluing the magnets to the back of the magnet
pocket.
All buyers of the JAG chassis are entitled to a
free replacement bare chassis once the injection molded chassis are
available.
Just pay for shipping or I can also include it with any order from JAG
Hobbies. |
Click here for parts.
Introducing the new JAG Hobbies, JAG-1.1, Chassis.
This chassis will allow you to install an inline
motor chassis on T-Jet "screw-on" bodies.
See pictures below of some examples of the chassis
installed on AW and Dash bodies.
 Features
3D Printed chassis
Inline Armature
Silicone Rear Tires
Metal Guide Pin
Coil Pick-up Springs
Long or Short Wheelbase
Bodies may require some modification or spacers to
fit properly.
Any and all comments are gladly accepted to make
this the best chassis available.
|
